The job (main+0x415300) hands the time manager's step to the sound system in its phase 0 and runs the sound objects'
and the system's updates in phases 1 and 2. With the set ostep that step is a fraction of a frame above 60 fps, and fed
fractions the game has been reported to keep sounds held after an area unloaded until no voice was free, new sounds
and then the music going silent until a restart. The new set osound (sound_steps, on by default) calls the page's
+0xf10 after the job's prologue: phase 0 adds the step to what the job is owed and runs once a whole step has built
up, phases 1 and 2 follow that choice, and a job that does not run gets phase 3, which returns through its own
epilogue. After phase 0's load of the step the page's +0xf00 makes a fraction one whole step. At 60 fps and below
the job runs every frame with the game's step. Both sites were checked against the module; frame_step_check covers
the gate at 60, 30, 144 and 240 fps. Needs the game code generated again.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The physics' two water managers and the game's interactive floor simulation (the Deku Tree's ground webs) step their
surfaces in fixed steps of 1/60 s, as many whole steps as the frame's time holds, and drop the fraction, so every
frame shorter than 1/60 s ran none and the surfaces stood still above 60 fps. The new set owater (water_steps, on by
default) calls the page between the division and the game's cut, which keeps the fraction per object; at 60 fps the
count is the game's.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The water renderer runs trunc(step) times the water's substeps of its ripple simulation a frame, which is none while the step is under one frame: the rings stood still above 60 fps. A new site of the set ostep hands the cut to frame_rate_water_host, which adds the step to a remainder kept for the water object and returns the whole steps in it. The waters have a table of 64 slots of their own, as fewer slots than surfaces would have them take each other's in turn.
frame_step_check.py calls the water and day hooks as their sites do. It also gets the three platform stubs it has lacked since the day clock's hook, without which it did not link.
Co-Authored-By: Claude Fable 5.2 <noreply@anthropic.com>
The day's update (main+0x3cdf70) adds trunc(2 x frames per update) game seconds a frame. With the set ostep's step,
the display interval in 60 Hz frames, that sum lost its fraction every frame: 1 a frame from 61 to 119 fps, 0 above
120 (the clock stood still), and at 60 fps a step a little under one frame dropped a second now and then. Its convert
now calls the patch page's +0xf60 (runtime/frame_rate.c frame_rate_day_host), which keeps the fraction per counter and
hands out the whole seconds. NX2NAVI_TRACE=perf logs, every 10 s, the seconds given beside those the cut would have
given.
Measured in Kakariko, 10 s windows: at a 60 fps limit 998 game seconds against 881 from the cut alone; at 144 fps
1,201 against 219 to 972 (the steady 1,200 a 10 s window should have).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
With it on, the game draws from a camera of the menu's instead of its own, in play and in cutscenes. The left stick moves it along its view and sideways, the right stick turns it, ZR and ZL raise and lower it, R makes it faster and L slower, and Link stands meanwhile; or the camera stays where it is and the pad plays the game.
It works inside the game's own camera update: a new patch site sends the instruction at which the frame's position, target and up vector are final to a host function, which replaces them for the camera that follows Link and the one the events direct, so the game draws, culls and loads detail for what the free camera sees. The camera of the interface's 3D models and the one the sound follows stay the game's. The set is off unless the menu switches it on. A teleport's arrival starts the free camera again from the game's view.
Tested in Hyrule Field with scripted stick input (turn, rise, strafe, with Link's position unchanged), with the pad playing while the camera stays, across a teleport to Kakariko Village, during the Kakariko arrival cutscene, and switched on by a click in the menu.
Co-Authored-By: Claude Fable 5.2 <noreply@anthropic.com>
Comments say what the code does and why, docs/maxwell.md keeps the Maxwell facts, and fetch_refs.sh clones only the checkout the build reads. Code is unchanged.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>