Files
NX2navi/tests
chrg6 da60e0d327 Make wb_lazy_unlocked = 0 bring back 0.10.1's locking in evictions and releases as well, which the review found it did not.
With the setting at 0, frz_lock was held across every fault's and release's fetch again and mem_thaw released under the
lock, but two parts of the new code stayed. vk_memory.c mirror_evict and hot_check still fetched their victims'
armed ranges before taking pool_lock again, and a release still put up to 16 copies in one submission. Those are the
parts that run only with a device and have no check without one, so a device loss caused by them was the one case the
switch could not take back. Now vk_memory.c reads the setting too (evict_unlocked, once on the replay thread, where
both run): at 0 neither drops pool_lock, and the release under it fetches everything, victim by victim, as before. And
memory.c lazy_take_batch_locked takes one segment at a time at 0, so each is fetched on its own.

What stays at 0 is the table of ranges in flight: a touch of a range being fetched waits for that fetch and runs
again (a write no longer goes on to thaw_fault and releases its region), the hold is set as the range goes out, and
mem_lazy_touches counts the range. memory.c "Ranges in flight", nx2navi.ini.example and docs/building.md say so.

tests/lazy_fetch_check.py gains locked_release, the release scenario at 0: three fetches of one copy each, where the
batched release makes two of up to two copies. It fails with the cap taken out. The eviction's side has a compile
check only. Not reproduced before the change; lazy_fetch_check passed in all its scenarios.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-13 20:12:50 -05:00
..