## Faster - **Experimental: the next frame no longer waits for the end of the last one's graphics work** (`tail_early = 1` in nx2navi.ini, off by default; contributed by epicmeme546). The game waits each frame until the graphics card has finished the frame before. The last of that work is the upscaler (FSR 4, FSR 3.1 or DLSS) and the interface drawn after it, and nothing the game reads comes out of it. With the setting on, the copies of what the card wrote for the game go before that last stretch and the game goes on once they are there, so the card finishes the picture while the next frame is already being prepared. The card runs the same work as before. On an RX 7900 XT with a Ryzen 7 5800X3D at 3440x1440, FSR 4 Native AA, Hyrule Field: 50.7 instead of 42.5 fps standing and 56.0 instead of 45.9 along a route; with `replay_workers = 3` as well, 63.5 instead of 49.4 standing. With FSR 3.1, whose pass is shorter, 51.8 instead of 47.8 standing. Its pictures matched standing, along the route and through warps to five areas, but it is new: leave it off to play, and report what you see if you try it. It does nothing without one of those upscalers, and nothing yet on NVIDIA and Intel cards, where the lazy write-back is on. ## Changed - **The draw replay on several CPU cores is off by default again** (`replay_workers = 0`). With three workers on by default in 0.9.1 and 0.9.2 some players' games ended with a lost graphics device; the cause is not found yet. The settings menu has it under Game, Testing, as *Replay workers (experimental)*: 0 to 8, after a restart.